LED display installation magnetic module splicing large screen installation steps

For some customers, if the LED display screen is fixed in one place, it is not necessary to spend too much money to buy the box. If the LED electronic large screen is installed without box splicing, how to splice the module into a large screen? Here is the mini photoelectric LED display manufacturers will explain how to use the magnetic stripe screen module splicing into a large screen, small module witness the great miracle!
Installation procedure diagram of LED display panel manufacturer’s magnetic module splicing large screen
Installation procedure diagram of LED display panel manufacturer’s magnetic module splicing large screen
Step 1: calculate the number of power supply and receiving card of magnetic suction module
First, calculate the number of modules according to the length, width, area and module model of the large screen Then calculate the number of receiving cards and sending cards.
Step 2: fix the back strip, receiving card and power supply
Fix the cut back strip at the installation position, and fix the power supply, receiving card and sending card, as shown in the figure below:
Installation procedure of magnetic module splicing large screen for LED display manufacturer
Installation procedure of magnetic module splicing large screen for LED display manufacturer
Step 3: mount the magnet to the module
Step 4: put the module on the bar screen
As shown in the figure below: put the module with the magnet screwed on to the strip screen, because the strip screen is the iron bar after plating clamp, it will not rust, and the magnet has magnetism, so the magnet can be adsorbed on the back strip and will not fall off. Before the mold is assembled on the strip screen, the power line and the row line should be connected well.
Step 5: after installation, light up the big screen
After installing all the modules, connect the wires and set up the program, you can use the large screen.
Splicing effect of P4 LED indoor display panel with magnetic absorption module
Splicing effect of P4 LED indoor display panel with magnetic absorption module
In the above five steps, it is easy to turn the small module into a large screen. This kind of magnetic bar screen is recommended to be installed indoors and in a fixed place. If it is a rental screen, it is not recommended to use this kind of screen, because the installation is too time-consuming and inconvenient for mobile use. If it is installed in a box, it can be installed quickly by directly using the lock between the box and the box. Of course, this magnetic bar screen is not recommended to be installed outdoors, because its waterproof performance is worse than the waterproof box.